Advanced Settings for VMware HA

After discussing the issue(s) about NFS.LockDisable and how those problems may be generated (ie: VMware HA initiation), a few comments came in about VMware HA and how the default settings may not fit their specific needs.

Well, here are some Advanced Settings that you can change from within your Cluster.

das.AllowNetwork By default the Service Console portgroup is used for failure detection. By entering in das.AllowNetwork you can specify an additional portgroup to use.

das.isolationAddress By default VMware HA nodes check heartbeats of other nodes . When this heartbeat is lost the suspected Isolated nodes then pings its Service Console gateway by default to check that it is truly isolated. By using the das.isolationAddress command, you can add additional IP addresses for the server to check. These IPs must be on the Service Console portgroup, or in the portgroup you’ve added for das.AllowNetwork

das.failureDetectionTime
This is the time required before VMware HA considers a host to be Isolated.
Default setting is 14 seconds, this can be changed to a setting that will better fit your needs.

das.failureDetectionInterval
This is the rate of monitoring between VMware HA nodes, think of this as a heartbeat check.
Default setting is 1 second, if you feel that this is just too often you can change it.

VMware HA events are captured in the vpxa.log file on each VMware ESX host. DasHostIsolatedEvent is the syntax left in the log file when an Isolation happens.

If you’re having problems with configuring VMware HA, you can check the /var/log/vmware/aam/aam_config_util_*.log files. These logs include all your necessary information for installing, configuring and connecting to other HA nodes.

If it comes down to it, you can remove the HA software from the ESX node by doing the following;

[root@dpcrc_vmdevsap1 aam]# rpm -qa |grep aam
VMware-aam-haa-2.2.0-1 <<< should be listed if installed
VMware-aam-vcint-2.2.0-1 <<< should be listed if installed
[root@dpcrc_vmdevsap1 aam]#
rpm -e VMware-aam-haa-2.2.0-1 VMware-aam-vcint-2.2.0-1

This will do a clean uninstall of the VMware HA software, you can then Reconfigure for VMware HA from within VirtualCenter.

Also, Duncan Epping over at yellow-bricks.com has a complete listing of Advanced VMware HA settings, you can check those out at http://www.yellow-bricks.com/2008/10/06/update-ha-advanced-options-2/


Created on October 20, 2008 by Rick Scherer

Posted under ESX 3.5 Tips, ESXi 3.5 Tips, VMware, VMware HA.

This blog has 31,829 views.

Tags: , ,

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)
Loading...

2 Comments so far

  1. Duncan
    6:18 am on October 25th, 2008

    I wrote down a complete list of the advanced options:

    http://www.yellow-bricks.com/2008/10/06/update-ha-advanced-options-2/

  2. Duncan
    11:01 am on October 25th, 2008

    thanks for the link!

Trackbacks

  1. Top referrers last 30 days » Yellow Bricks November 28, 2008 1:22 pm
  2. Virtualization Adapted June 26, 2009 10:16 pm

Leave a Comment

Name (required)

Email (required)

Website

Comments

More Blog Post